Home Blog Page 417

Any Issues with A 2005 Polaris Super Sport?

Question:

I purchased a left over ’05 Polaris Super Sport. Are there any issues with this particular sled? I have also installed a 1 1/4″ ripsaw track, does this sled have enough power to get the most use out of the higher lug track? What can I expect in the way of performace from the 550 motor? Any information will be appreciated.

Submitted by: Mike Rohwedder

Response:

Wow! I can’t believe you scored a brand new 2-year old Supersport. Good sled! Any reports I’ve heard about the cylinder reed 550 fan SS is that it’s a very bulletproof engine. In fact, one of our staff members, John Arkwright, had one in his personal fleet for a few years.

My biggest complaint with this year/model was that it didn’t offer composite skis from the factory. Your particular model uses the iron liner mill (the 2007s have Nikasil liners and a throttle position sensor) like the 2006. Our understanding is that the 05 makes about 62 horsepower.

Frankly, the 1.25 track probably won’t make much difference unless you’re riding in powder snow a lot. In this setting it will prevent you from getting stuck as often.

With 60-62 HP on tap you’re likely going to see a decrease in top speed by a couple of mph with this track but you’ll hook up better off the line and on trails.

Kent Lester

Lanaudiere, Quebec – Runways and Rubdowns

0

Year after year the Lanaudiere Region continues to deliver superb trails with excellent signage, plenty of pit stops, warm hospitality and breathtaking scenery around every corner.

It is close to major urban centers (Ottawa and Montreal) and the USA border and manages to get the right amount of white stuff dumped over its endless miles of groomed trails every winter.

Lanaudiere should claim the publishing rights to Self Guided Snowmobile Tours for Idiots. The region’s trail maps are so thorough and easy to follow even city slickers can roam its snow-covered highways with confidence.

Don’t worry about looking too hard for a map either. Every gas station, restaurant and pit stop stockpiles them in the lobby. Several color-coded tours specifying mileage and points of interest plus lodging, restaurants and service centers are mapped out.

Lanaudiere is very security conscious and many hotels have excellent, secure parking for your truck, trailer and snowmobile.

Once you’re on the trail your map can be tucked away as signs clearly point you in the right direction and give distances to key destination points. There’s always a delicious meal waiting for you when you’re ready to call it a day.

The accommodations in this region maintain an inviting French flare but, make no mistake about it, Americans are welcomed with open arms.

In fact the restaurant and hotel industry in Lanaudiere relies largely on American snowmobile tourism and goes out of its way to keep you coming back. Next time you visit Lanaudiere check out the array of plates from NY, PA, OH, MI, VT and Maine.

Many of the hotels (auberges) have professional spas and there’s nothing like a hot tub and personal massage after adding a couple hundred miles to your odometer. The hospitality service in this region needs to be experienced firsthand to be fully appreciated.

Since we make a point of visiting Lanaudiere every year we have become experts,on this captivating region of Quebec. If your looking for a snowmobiling experience where you can do it yourself yet feel like you’re world’s away, we assure you, this winter, Lanaudiere memories will last forever.

Written by: Matt Lester

Visit www.snowmobilecountry.ca or call 1-800-363-2788 for more information.

Be sure to ask about the following places:

L’Auberge du Lac Taureau 1-877-822-2623
L’Auberge Matawinie 1-800-361-9629
Hotel Montcalm 1-866-424-1333
Spa Thermo-Riviera 1-819-424-1654

Hibbert’s Return To Snocross

Arctic Cat recently announced the return of Tucker Hibbert to Team Arctic racing.

Tucker has committed to racing about half of the WPSA National Tour (when there are no conflicts with his AMA motocross racing program) and will certainly participate in ESPN’s legendary X-Games snocross competition.

Hibbert left Team Arctic three seasons ago amidst a cloud of controversy. Some believed management personality conflicts were at the core of Tucker’s way-too-early retirement.

With what appears a complete housecleaning in the legendary halls of the Arctic Cat Race Shop and the installation of Russ Ebert as AC Racing Boss, it may be time for Tucker to return to dominance in the sport.

New Colors From United Trailers

0

United Trailers customers can now mix and match color combinations to coordinate with their snowmobile!

12 color combos are available. These trailers feature standard steel uni-body construction, Dexter® Independent Torsion Axles, E-Z® Lube Hubs, 3/4” Wolmonized plywood on floor and ramp doors.

Also, these options are available: two-tone metal treatment, aluminum star wheels, side-access doors and bright aluminum on the nose of the trailer.

Contact United for more details at 1-800-637-2592 and visit United-Trailers.com

Finally, A Yamaha Rumor!!

We remember when it was tough to dig up a rumor about a Yama-rocket. Not any more! Look for model year 2008 (that’s next year) to intro a radically re-engineered Vector chassis.

We think Yamaha will do to the Vector what it did to the RX-1 two years ago when it morphed into the Apex. Look for the debut of a new rider forward ergonomic package with a shortened hood similar to the Apex.

Clearly the Big Y is not content to sit still these days and with everything else in its camp becoming rider forward in design, the rider-over-tunnel Vector has to be next in line to get an update.

We don’t think the engine – probably the best 4-stroke mill in the industry right now, will change much except for the possible addition of EFI.

SKI-DOO EXO SERIES HELMETS

0

We just received new Ski-Doo EXO 700 helmets to keep our melons safe this season. Aside from the beautiful appearance the EXO helmet offers some pretty slick features too.

A bonus to anyone who’s ever had a run in with a low branch on the trails is the optically correct fog free face shield featuring an anti-scratch hardened coating. At one time you were thankful for the protection, but you then had a blind spot in your line of sight. With the Everclear technology, this could be a thing of the past.

Also note the adjustable and removable moisture wicking liner, breath deflector for further fog resistance and the Speedshift quick-change shield system to make tool-free face shield changes in 10 seconds or less!

Click the banner on the left of this page more about Ski-Doo’s EXO helmets.

Ski-Doo 2-Stroke Technology

0

The Series III Rotax 600 engine is a formidable powerplant when equipped with Ski-Doo’s Semi-Direct Injection EFI system. SDI allows for super efficient scavenging, impossible on a conventional throttle body 2-stroke EFI system.

With four injectors located in the transfer ports, fuel only comes into play at the last millisecond (at less than 30 degrees of crank rotation) before the intake port closes. More important is the rapid injection of fuel only after the exhaust port has been shut by the rising piston. All this techno-jargon means this: no wasted fuel is spewing into the pipe.

SDI relies heavily on a knock sensor to back fuel mixture down to extremely lean levels. The system’s ECU recalibrates itself to verify fuel quality every single time the engine is started. After selling thousands of SDI’s the past four models years Ski-Doo’s 600 has proven to be bulletproof, incredibly fuel efficient and plenty powerful at a claimed 118 horsepower.

It’s recommended you use high quality synthetic and we think that’s good advice, considering the way the engine sips lube. We’ve been amazed at how little oil an SDI uses during a day’s riding. Having said this, it’s something you have to look after that a 4-stroke doesn’t require.

Fuel economy recorded the past three seasons verifies consistent mileage in the low 20’s. The EPA emissions numbers are interesting and demonstrate the inverse hydrocarbon to carbon monoxide ratio 2-strokes often demonstrate when compared to 4-strokes of similar power. The 600 SDI produces 70.2 gpkw of hydrocarbons and 126.5 gpkh of carbon monoxide.

For those who want more beef this year, there’s Ski-Doo’s impressive 800 PowerTek engine. This 138hp cylinder reed 2-stroke is a bit of a marvel in the industry as it doesn’t use the electronic wizardry of SDI to get clean exhaust ratings.

With carburetors, careful tuning and a detonation sensor it ekes out a miserly 72.8 gpkh on the hydrocarbon scale and 200 gpkh of carbon monoxide. Although not the cleanest certified engine in the business, it still falls well within the parameters set by the EPA without incurring cost-ups from expensive technology.

It’s likely this is the last year for this 800 as consumer testing is currently taking place in the mountains of our continent on a completely new Rotax engine – the 800R. It’s lighter, more efficient, cleaner and cranks an incredible 152 ponies, again using only carburetors.

Click the banner at the top of the page for more about Ski-Doo’s 2-TEC SDI engines.

POLL RESULTS

0

Our last poll question asked you how much has your impression of 4-stroke snowmobiles changed in the last two years. The results were as follows:

28.85% – Definitely buying one
28.08% – Still wouldn’t consider buying one
16.54% – Much more interested
13.85% – Thinking about buying one
12.69% – A bit more interested than 2 years ago

Scroll down to vote in our latest poll!

Question:

How much does EPA certification mean to you when considering a new sled purchase?

Glide Washers: Will They Make a Difference?

Question:

I found the following description for Thunder Products Glide Washers:

“Drive Clutch springs are in constant motion, being subjected to compression, rebound, end to end radial torquing, distortion, and vibration. “Glide Washers” are custom made with a baked-on lubricity coating. By placing a washer on each end of the spring it can no longer bind on the spyder or clutch cover.”

What do you think would be the benefits of installing these glide washers on my Crossfire 7? In other words would I notice any difference?

Submitted by: Kerry Johnson

Response:

Thanks for your question.

The concept of seating a clutch spring at both ends in a high density plastic or lubricant impregnated washer is not new. BRP Ski-Doo uses a similar principle in their TRA III clutch.

We assume this is for all the reasons you mentioned in your question. I am also assuming the Thunder Products Glide Washer you are referring to is more than just a washer but actually covers the side of the spring at both ends. This would alleviate any potential binding of the spring against the side of the spider and cover.

Undeniably, this would be a benefit if the design of the Arctic Cat clutch in your CF-7 is prone to this problem. At this writing I do not know if that is inherently true. Your question has sparked my interest and I will pursue a further investigation – possibly because I’m a nut.

Okay, the real issue is this – Can you (or I) tell the difference such an accessory would make? Maybe. In the case of a trail sled where you might run a clutch spring for 5000 miles and/or never change it, you would probably benefit from a spring change more than the installation of this kit.

In other words, if you’re looking for a big improvement in performance, tune up your clutches more often and do the basic stuff like weight and roller bushing inspection/replacementand/or lubrication and the installation of a new spring.

In the case of a hard core rider who is regularly cleaning and tuning his clutches, this kind of modification will probably net a result which the rider can detect – because of their attention to clutch performance and the resultant affect any modification makes to the primary’s ability to transfer power.

Snowmobile CVT tuning has always been a black art. This will continue as more technology emerges from both the OEM’s and the aftermarket. At the end of the day it’s about maintenance for the average rider.

If you have more than 2500 miles on your Scooter and haven’t touched the clutches, I’ll pretty much guarantee you’ll be shocked at the improvement in performance and fuel economy you’ll get from a cleaning, inspection and replacement of worn parts and the installation of a new spring.

For the tuner it’s about all-out absolute high performance. For the trail rider it’s about practical maintenance and a return to the performance the sled delivered when new.

Hope this helps.

Motorhead Mark

REV Tunnel Bag by GEARS Canada

0

This heavy duty 1200D Techolast, UV treated polyester tunnel bag features a polyurethane coated outer and inner shell.

The easy grip rubber handle will last forever and reflective beading is a great safety feature.

The easily removable CAM buckle system is super convenient. Fits compactly on sled’s tunnel.

Call 905-737-3081.