Home Blog Page 404

How To Transfer Weight To The Track

Question:

How do you transfer the weight to the track on an MX Z 1000?

Don

Response:

Weight transfer is achieved in a greater measure by a combination (or any one) of these items.

* Soften the rear torsion springs
* Increase the preload on the front arm coil-over spring
* Let out the front limiter strap
* and most importantly increase bite (add traction products to the track).

You can also increase weight transfer by simply moving your butt and feet back on the running boards and seat and pulling on the bars when you launch.

Mark “Motorhead” Lester

BLAIR MORGAN FANTASY CAMP

The inaugural Blair Morgan Fantasy Camp, a Fundraising Event is scheduled from March 28-30, 2007 in Revelstoke BC.

Glacier House Resort has generously provided meals, accommodations and snowmobiles for the camp.

There will be at least 4 public “seats” available at the camp to be auctioned on e-bay starting Feb 9th and each week one auction will close from Feb 19 until March 12.

Proceeds are donated to support the charity shootforacure.org to benefit Spinal Research through csro.com for Canadians and asro.com for Americans.These two organizations participate in global research efforts.

Participants will be provided accommodations, meals and a snowmobile to hangout and ride with Blair Morgan, the participating sponsors and supporters of Skidoo’s Blair Morgan Racing Team. Tax receipts are available.

Transportation from a regional airport to and from the camp will be provided. Participants traveling by air must arrange their own travel to either airport in Kamloops BC or Kelowna BC. Connections are available in Vancouver BC or Calgary AB.

Blair Morgan and the Blair Morgan Racing Team want to promote safety and participation in motorsports including snowmobile racing. We want to raise awareness of the risk of spinal injury and the research efforts to find a cure.

For more information visit bmrt.com.

More Power For 800 Summit HO

Question:

I have a 2006 800 H.O. Summit and I would like to squeeze some more horsepower out of my sled.

Any suggestions?

Troy

Response:

Thanks for your email!

Your question needs some qualification.

Sure, you can increase HP but how much $$ do you want to spend and how much of a compromise are you willing to make for torque and reliability?

More peak HP will decrease torque – torque is what makes you move in the mountains – HP is elusive and hard to capture (clutch) efficiently at altitude. The Series III 800 engine you have is not known for super long term crank durability when modified.

I would recommend only basic enhancements like V-Force reeds and possibly a torque single pipe. Again, it’s about $$.

Motorhead Mark

Gueco, Apex RTX Win Soo I-500 Enduro

Press Release –

For the second consecutive year, a Yamaha Apex snowmobile has won the prestigious Soo I-500 endurance race in Sault Ste. Marie, Mich. The winning team of Chad Gueco and co-driver Bill Wilkes simply dominated throughout the entire event on Saturday, Feb. 3.

Last year’s winner Corey Davidson, driving with Travis Hjelle and Troy Hanson, put another Apex on the podium in third. Filling out the top five for Yamaha was the Loshaw Racing RX-1 of Shawn Ritchie and Terry Wright.

Gueco set up his Apex’s suspension for the rough conditions expected during the scheduled 500 miles, and although he qualified only 11th, he knew the powerful Yamaha would still handle well when conditions deteriorated.

Still the competition was fierce – much of the strongest was from other Yamaha teams – and the Gueco Racing Apex ran in the top three for most of the first 200 laps.

The only mechanical issue occurred at the 200-mile point when the team pitted to replace an idler wheel. But they reclaimed the lead and had built up nearly a lap advantage when the event was red-flagged on lap 367 for a fast-moving snowstorm.

Gueco and Wilkes were declared the winners while Davidson, Hjelle and Hanson, charging hard in third, simply ran out of time. Moving up field after receiving a stop-and-go penalty, they had un-lapped themselves and were chasing down the leaders when the race was stopped.

“I have always loved endurance racing because it’s a challenge, a strategy game, trying to outsmart the other racers,” Gueco explained later. “Yamaha builds a great sled and the Apex four-stroke engine never missed a beat the whole race. This thing has so much steam down the straight-aways! It pulled the same rpm every lap and we never had to worry about the engine at all.”

’99 Mach-Z Gasket, Compression and Top RPM

Question:

I own a ’99 Mach-Z and I’d like to know which gasket between 0.3, 0.4, 0.6 mm is better and also what is the compression and top rpm.

Thanks,

Erik

Response:

The highest compression ratio will be achieved with the .3mm base gasket. Premium fuel must be used at all times if you go this route. Otherwise use the one that was originally on the engine.

The cold cranking compression is approx 135-140 lbs. We don’t print this due to variations in gauges and conditions. It is just a basic indicator of a healthy engine.

Any good performance shop will CC the cylinder head and combustion chamber if performing modifications.

The RPM if stock pipes are used is approx 8100. Later models turned slightly higher RPM closer to 8200-8300.

Hope this helps.

Gordie Radtke
Ski-Doo

SUPERTRAX Was Right About The Phazer

0

I early ordered my new Phazer in April last year. I don’t usally buy the first model year of any sled but the press seemed to like this model so much I ditched my ’04 Venom and hoped for the best.

I have 450 miles on it now and other than the tunnel icing up from the gaping hole (I’m sure Yamaha Will have a fix for next season) this thing rocks.

I get 23 miles to the gallon (CDN) and at 44 years old I feel like a snowcross racer.

It truly feels light and has enough power to keep 75% of the snowmobile world happy.

Thanks for your honest input and keep up the good work.

Robert Tucker

Jetting The 600 HO Fusion

Question:

Hello,

In the 1/10/07 article, Kent Lester mentioned something about jetting the 600 HO Fusion, carefully.

Could you give me more info on this. I have one of these sleds and have a problem with bogging down at cold start-up. Will this help me?

John Janssen

Response:

John:

Polaris carbureted 600HO engines use both a throttle position sensor and a knock sensor. The TPS reports the rider’s demands on the engine and communicates with the knock or detonation sensor.

Knock sensors enable the engine to run much leaner with stock jetting (ie: the stock jetting is set much lower from the factory than with a non-knock sensor engine).

The knock sensor basically tells the engine’s control unit to either advance or retard the timing when the engine is too lean or too rich. (advance when rich, retard when lean).

A bog usually indicates a too-rich mixture (timing retarded) and this may be a timing setting Polaris has programmed-in when the engine is first started so you don’t cook a cold engine.

I know some owners have leaned out their mains a size or two (depending on elevation) on this sled with good results but the net gain may not be worth the risk depending on how you ride.

If you run big lakes at wide-open throttle you could be running too lean up top too long. If you’re trying to beat someone in a drag race, running short bursts at WOT, the leaner settings may work for you.

You may just want to try being more patient, letting the sled warm up completely and let the electronics do their thing.

Kent Lester

’06 Mach Z Comments

Question:

2006 Mach Z . No electric start. No 1 1/4 track. The best thing is that at 100 mph I go around my brother’s Apex GT.

If I could only start it and get a holeshot like the Yamaha he would have bought a Mach Z.

Jim Martin

Response:

Yeah, I know where you’re coming from. The Apex pulls good holeshots because 4-strokes make their biggest torque at low RPM – right off idle and up through the midrange. That’s what makes them feel so torquey all the time – because that’s here most people are riding.

Actually the Apex may produce a little less peak torque than the Mach. The 2-stroke Mach needs RPM to generate its biggest torque numbers.

Try this: Do a roll-on side by side at about 60 mph with the two sleds. The Mach Z will catapult away in this range – (and should, considering it’s making about 20 more horsepower).

The Mach’s ample torque from about 6000 RPM up easily overcomes the parasitic drag of the chassis and the friction of the track on the snow etc.

4-strokes tend to have a really broad, flat torque curve and 2-strokes torque curves tend to peak more sharply.

I’ve heard rumors about some starting problems with some Ski-Doo 1000s but don’t have an answer for you. Maybe this posting will stir up some discussion.

Have a safe winter.

Kent Lester

POLL RESULTS

0

Our last poll asked you which is the best ultimate 1000. Out of 1,260 votes, the results were as follows:

38% – Ski-Doo Renegade (482 votes)
21% – Yamaha Apex (260 votes)
18% – Arctic Cat F1000 (221 votes)
16% – Yamaha Attak (202 votes)
08% – Crossfire 1000 (95 votes)

Scroll down and vote in our latest poll!

Question:

The late arriving snow this winter has caused me to:

1. Make no changes in my winter riding or sled purchase plans.
2. Wait until next year to make a new sled purchase.
3. Cancel an order I’d made for a new snowmobile.
4. Refurb my old sled in lieu of buying a new one.
5. Get out of the sport.

Polaris Freestyler Takes Silver & Gulla Takes 3rd

Press Release –

Aleksander Nordgaard Lands Record-Setting Backflip to Earn Silver

Polaris snowmobile freestyle rider Aleksander Nordgaard of Norway landed a record-setting backflip on his final jump and earned a silver medal with a second-place finish at the ESPN Winter X Games on Sunday night.

Nordgaard scored 93.66 points in the final in Aspen, Colorado, and was beaten by just 2 points by gold medalist Chris Burandt.

In X Games Snocross, four Polaris racers qualified for the 12-man final held on Saturday night, and TJ Gulla (Hentges Racing) finished third to earn an X Games bronze medal.

FREESTYLERS MAKE HISTORY

In the first-ever X Games Snowmobile Freestyle competition, two Polaris riders qualified for the four-man semi-final round. Nordgaard was joined in the semis by fellow Polaris rider Daniel Bodin, a 22 year old from Sweden.

Bodin had been the first alternate and was moved into the competition when other riders were injured. He took full advantage, scoring well in the preliminaries to reach the final four.

In the semi-finals, Nordgaard beat Bodin to advance, while Burandt, widely recognized as the world’s best freestyler, beat Heath Frisby.

Nordgaard rode first in the final round and launched his Polaris IQ sled off jumps into numerous backflips. On his final jump, he performed a final backflip and landed 106 feet from the ramp, a new world record distance.

Burandt followed and performed several outstanding tricks as well as multiple flips to earn the gold medal.

TJ GULLA TAKES THIRD IN SNOCROSS FINAL

Four Polaris racers – including three from Hentges Racing – qualified for the Winter X Games Snocross Final held Saturday, January 27.

Hentges Racing teammates T.J. Gulla, Levi LaVallee and Brett Bender made the final, as did Mike Schultz of Avalanche Racing.

In the final, Gulla was among the many racers who got caught up in thick traffic at the first corner. Several sleds ran close together through the first lap before Gulla broke clear. He made several passes to work his way up to third, allowing him to earn a spot on the podium and a bronze medal.

LaVallee, who won the silver medal last year, didn’t break clear of the traffic early enough to mount a challenge, he finished sixth. Schultz finished ninth and Bender finished 11th.

The snocross final was won by Tucker Hibbert, who earned the second X Games gold medal of his career.